| After a week of
fabricating, the floors from frames 16-20 are now welded into the hull to
hold the keel case in place. (Right)
|
 |
Also shown the
keel case hanging vertically and some of the water/fuel tanks either side of
the floor frames. (Left) |
 |
A week I have
waited for, the keel is finally part of the hull, after several days of
difficult welding.
Left: looking along the hull and
through the floor frames.
Right: Looking at the keel case from
inside the hull, showing the frames or 'boat's ribs'. |
 |
| A great week, the
last two plates have been fitted and tacked. The hull is complete. (Right) |
 |
Off to
Southampton Boat Show tomorrow to order the JCB/Mermaid Engine, PRM gearbox
and feathering propellor. If
you've enjoyed looking at this site, please send us an email titled "BIG1
Feedback". |
| |
|
|
